Mavic Mini Mavic Mini firmware update v01.00.0400

[wdejager]

DJI heeft op de valreep van 2019 een firmware update beschikbaar gesteld voor de Mavic Mini. Ook de DJI Fly app heeft een update gekregen. Niet alleen zijn er de nodige bugs geplet, ook is er een nieuwe feature bijgekomen die de gebruiker in staat stelt om GEO zones te deactiveren.

Overview new firmware update DJI Mavic Mini

• Date: 2019.12.31
• Aircraft Firmware: v01.00.0400
• Remote Controller: v01.00.0400
• DJI Fly App iOS: V1.0.4
• DJI Fly App Android: V1.0.4

What’s new

• Added feature to unlock GEO zones (requires DJI Fly v1.0.4 or later).
• Added feature that disables takeoff when the GPS signal is weak (GPS <8) and the environment light is not sufficient. This feature can be disabled manually (requires DJI Fly v1.0.4 or later).
• Added requirement for compass calibration before takeoff when the environment light is not sufficient and the compass experiences interference.
• Adjusted flight altitude and distance in payload mode.
• Added warning prompt for battery cycles.
• Reduced noise during self-diagnostics after powering on.
• Fixed issue: linking was abnormal in some regions.

Notes:

• Note that the update may reset various main controller settings, such as the RTH altitude and the maximum flight distance, to default settings. Before updating, take note of your preferred DJI Fly settings, and readjust them after the update.
• If the update fails, restart aircraft, remote controller, and DJI Fly or DJI Assistant 2 for Mavic, and retry.